这是TTL的信息，似乎刷进去了。就是不起来。BUFFALO U-BOOT Ver 1.00
  == CPU:680MHz, DDR:340MHz, AHB:170MHz ==
AP96 (ar7100) U-boot 0.0.1
DRAM:  128 MB
Top of RAM usable for U-Boot at: 84000000
Reserving 265k for U-Boot at: 83fbc000
Reserving 192k for malloc() at: 83f8c000
Reserving 44 Bytes for Board Info at: 83f8bfd4
Reserving 36 Bytes for Global Data at: 83f8bfb0
Reserving 128k for boot params() at: 83f6bfb0
Stack Pointer at: 83f6bf98
Now running in RAM - U-Boot at: 83fbc000
flash bank #0 found 16 MB flash [W25Q128BV, blk:0x10000, sectors:256]
flash bank #1 found 16 MB flash [W25Q128BV, blk:0x10000, sectors:256]
Flash: 32 MB
In:    serial
Out:   serial
Err:   serial
Memory Test
uboot use  83F6BFB0 - 84000000
Memory Test start(80000000) end(83F00000) size(03F00000)
Pattern 00000000  Writing...  Reading...
Memory Test start(84000000) end(88000000) size(04000000)
Pattern 00000000  Writing...  Reading...
Memory Test OK
### buf_ver=[1.00] U-Boot Ver.=[1.00]
### build_date(env)=[Jun  1 2010 - 13:48:44] build_date(bin)=[Jun  1 2010 - 13:48:44]
ag7100_enet_initialize...
Reading MAC Address from ENV(xxxxxxxx)
Port 0, Neg Success
Port 1, Neg Success
Port 2, Neg Success
Port 3, Neg Success
eth0: Phy Specific Status=0010
eth0: Phy Specific Status=0010
eth0: Phy Specific Status=0010
eth0: Phy Specific Status=0010rleth0: 02:aa:bb:cc:dd:20
eth0 up
Reading MAC Address from ENV(xxxxxxxxxx)
Port 4, Neg Success
eth1: Phy Specific Status=0010
eth1: 02:aa:bb:cc:dd:21
eth1 up
eth0  02:AA:BB:CCD:20
, eth1  02:AA:BB:CCD:21

eth0 link down

tftp server(receive) go, waiting:4[sec]

enet0 port0 up
pll reg 0x18050010: 0x110000  Load address: 0x84000000
checksum bad
checksum bad
checksum bad
checksum bad
$checksum bad
O $$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
         $$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
         $$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
         $$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
         $$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
         $$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
         $$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
         $$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
         $$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
         $$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
         $$$$$$$$$$$$$$$$
tftp server done
Bytes transferred = 3408080 (3400d0 hex)
change bootargs
console=ttyS0,115200 root=31:03 rootfstype=jffs2 init=/sbin/init mtdparts=ar7100-nor0:256k(u-boot),64k(u-boot-env),1152k@384k(uImage),6592k@1536k(rootfs),64k@320k(ART),64k@8128k(properties),8192k@8192k(flash1),16384k@16384k(flash2) mem=128M
## Booting image at bf060000 ...
Bad Magic Number
# LED(0x2) Blink[2] (Please press 'Ctrl+c' to stop)

本帖最后由 陀飞轮 于 2016-3-15 22:01 编辑

可以换个其他版本的固件试试：

AA版
https://downloads_openwrt_org/attitude_adjustment/12.09/ar71xx/generic/openwrt-ar71xx-generic-wzr-hp-ag300h-squashfs-tftp.bin

BB版
https://downloads_openwrt_org/barrier_breaker/14.07/ar71xx/generic/openwrt-ar71xx-generic-wzr-hp-ag300h-squashfs-tftp.bin

是要掌握时间点。
但根据我以前操作经验，进度条动了，基本就成功了。不知道你的具体情况，或者多试几次，再或者换官网上其他版本的固件试试（比如bb版带tftpupgrade的那个）。
本帖由 Huawei 客户端发布

下载了15.05，放到tam下强刷，启动后进不去了。登录IP试了一遍，不行。不知怎么回事。

root@OpenWrt:~# upmpdcli –D –c /etc/upmpdcli.conf

upmpdcli: can't load library 'libupnpp.so.2' 又遇到这个情况。

upmpdcli在Chaos Calmer版才有，Barrier Breaker版没有。
你现在的是Barrier Breaker版。

厉害，学习一下

就是您推荐的300H.    OpenWrt路由    型号Buffalo WZR-HP-AG300H/WZR-600DHP    CPU型号Atheros AR7161 rev 2    CPU主频680 MHz 内存频率340 MHz 闪存容量32 MB        固件版本OpenWrt Barrier Breaker 14.07 r47805 元旦版 by 明月永在 本帖最后由 陀飞轮 于 2016-3-12 19:39 编辑

  _______                     ________        __
|       |.-----.-----.-----.|  |  |  |.----.|  |_
|   -   ||  _  |  -__|     ||  |  |  ||   _||   _|
|_______||   __|_____|__|__||________||__|  |____|
          |__| W I R E L E S S   F R E E D O M
-----------------------------------------------------
BARRIER BREAKER (Barrier Breaker, r47805)
-----------------------------------------------------
  * 1/2 oz Galliano         Pour all ingredients into
  * 4 oz cold Coffee        an irish coffee mug filled
  * 1 1/2 oz Dark Rum       with crushed ice. Stir.
  * 2 tsp. Creme de Cacao
  * This firmware is compiled by rapistor(鏄庢湀姘稿湪). QQ 273584038
-----------------------------------------------------
这怎么改啊？

谢谢！见笑了！
root@OpenWrt:~# opkg install mpd-full
Unknown package 'mpd-full'.
Collected errors:
* opkg_install_cmd: Cannot install package mpd-full.估计是源不对？

本帖最后由 陀飞轮 于 2016-3-12 18:47 编辑

请再指点一下：root@OpenWrt:~# opkg install Download http://www_musicpd_org/download/mpd/0.19/m
pd-0.19.13.tar.xz
Downloading http://www_musicpd_org/download/mpd/0.19/mpd-0.19.13.tar.xz.
Collected errors:
* deb_extract: /tmp/opkg-6H7lm9/mpd-0.19.13.tar.xz: invalid magic
* pkg_init_from_file: Failed to extract control file from /tmp/opkg-6H7lm9/mpd-0.19.13.tar.xz.